Drilling cuttings dryer is mainly used for drilling fluid recovery in drilling cuttings, recycling drilling fluid with reuse value in cuttings, reducing the cost of drilling fluid in the drilling process, and meeting the transportation and environmental standards of drilling cuttings. The first use of the drill chip dryer needs to pay attention to the installation and debugging methods so that the equipment can operate safely and stably.
During the installation process, we must first ensure the safety of lifting and check whether all the lifting points of the equipment are firm and safe. When installing, ensure that the installation table is clean and tidy to prevent debris on the installation table from affecting the installation. To ensure the safety of the equipment during transportation, special transportation protection devices are installed, which must be removed after installation to prevent damage to the dryer, and then install all the pipelines, and the electric control system of the dryer, be sure to carefully read the electric control operating instructions before the installation of the electric control system.
After the installation of all the relevant equipment, you can start debugging, before starting, be sure to check the integrity of the installation of the equipment, whether there is leakage or installation. Check whether transportation protection devices are removed. Turn the motor pulley by hand to see if there is any abnormal situation such as congestion and check whether the belt is damaged and whether the tightness is appropriate, but check whether the oil level of the tank is appropriate, and check whether all the pipelines are connected, and check whether all the electric control system is connected in place.
After the boot check, you can click the oil pump motor to check whether the motor rotation direction is correct, the motor is clockwise rotation if not correct, timely adjustment; Point the main motor, and observe whether the rotation direction of the distribution disk is correct, and observe whether there are other abnormal conditions, from the top down, the rotation direction should be clockwise rotation; Move the feed pump, observe whether the rotation direction of the feed pump is correct, and check that the above items have no problems, you can start the equipment for debugging production.
